VAV B 10/20/30 Series
Type: Rectangular / Round
Heavy Duty Models VAVH B – 10/20/30 For High Pressure Applications
Heavy duty type Bypass , Pressure Independent and Pressure Dependent VAVs’ are manufactured for high pressure applications
Data
Technical Features:
- Volume control range from 100 to 10% is possible to the
conditioned zone. - Accurate airflow sensing with 2 X 12 points averaging.
- Low Leakage i.e. less than 2% of V nominal at 750 Pa.
- Designed to produce low NC levels with minimal
pressure drop to the system. - Suitable for use as constant volume application,it can
maintain a set flow requirement, compensating for
fluctuations in system pressure. - Suitable for single duct variable volume control
- Air volume capacity upto 2800 CFM
- Electronics control factory supply & mounted.
- Variety of control options available, based on
applications. - Electronic thermostat & actuator provide accurate
mounting control. - Metal encapsulated edges limit fiberglass insulation
erosion into the airstream. - Single-point power connection reduces installed cost.
- Maintenance free.
- AHRI Certified
Standard Construction
Casing
1.2 mm thick galvanized sheet steel.
Insulation
25 mm thick 32 kg/m³ density Acoustic liner.
Blade
0.9 mm thick aluminium extruded aerofoil multiple blades.
Flow grid
Flow grid multi point with 12 inlet holes in four concentric
circles.
Axle Shaft
12 mm diameter axle shaft made of galvanized steel.
Bearing
12 mm diameter Brass bearings.
Neoprene Gasket.
Controls :
Modulating / On-Off.
Optional Fittings
Controls
Backnet DDC with suitable thermostat.
Sound Attenuator
VAV with additional length insulated casing for sound
attenuation.
Duct Heater
Slip-in type electric duct heater (230V AC 1 Phase or
400V AC 3 Phase)
Double skin
Insulated internal walls surface with Galvanized perforated
sheet used for low noise applications to minimise breakout
noise.
Neck connections
Round inlet with round outlet and square inlet with square
outlet.